1. According to the required voltage, first adjust the “coarse adjustment” knob, and then gradually adjust the “fine adjustment” knob to make the correct fit. For example, when you need to output 12V voltage, you need to set the “coarse adjustment” knob to 15V, then adjust the “fine adjustment” knob to adjust 12V, and the “coarse adjustment” knob should not be placed at 10V. Otherwise, the maximum output voltage is less than 12V.
2. After adjusting to the required voltage, the DC power cable is connected to the load.
3. In the process of use, if you need to change the “coarse adjustment” file, you should disconnect the load first, and then adjust the output voltage to the required value before connecting to the load.
4. In the process of use, when the load is short-circuited or overloaded, the load should be disconnected first, then press the “Reset” button, or the power can be turned back on, the voltage can be restored to normal operation, and then the fault is re-accessed. load.
5. When the power supplies of different rated currents are used in series, the output current is the rated value of the lowest rated value.
6. Each DC power supply wire has a meter head that indicates the output current or output voltage of the local circuit when the A/V is in different states. Usually placed in the voltage indication state.
7. Each DC power supply wire has two red and black output terminals. The red terminal indicates “+”, the black terminal indicates “-”, and the black terminal with the “earth” symbol in the middle of the panel indicates that the terminal is connected to the chassis. , there is no electrical connection with each output, only used as a safety wire. It is often taken for granted that the "earth" symbol indicates grounding, and the "+" and "-" indicate positive and negative power outputs to power dual-mode op amps.






