MDR 20 Pin Male To CN20 Pin Signal Data Cable For CN20 Breakout Terminal Block Servo Drives

Starte makes MDR 20 pin male to CN20 pin signal data cable. This SCSI II 20-pin to MDR 20-pin connector cable with screw is always used to provide data transfer when you connect Mitsubishi J2S servo motor axis terminal board with MDR20 pin female connector.
You can also find CN20 20-Pin MDR SCSI I/O Connection Cable is also matched with CN20 breakout terminal block servo drives, SCSI 20 Pin MR-J2CN1 Servo Connector Breakout Board.
This MDR20 pin Servo Data Connector cable with screw features a SCSI 20 Pin 20P MDR Male CN Wire Mount Plug Drive Connector on each side, made with UL-list 28AWG*10Pairs twisted shielded wire, compatible with Yaskawa, Delta, Panasonic, Mitsubishi driver signal line SH21 bus.